Cold Air Intake for Ford Ranger (1998-2001) V6 3.0L Engine

Cold Air Intake System for Ford Ranger & Mazda B3000 3.0L V6 (1998–2001)

Unleash the hidden performance of your truck with this High Performance Cold Air Intake System, engineered specifically for 1998–2001 Ford Ranger and Mazda B3000 3.0L V6 engines. Designed to replace the restrictive factory air box, this intake delivers increased airflow, improved throttle response, and a more aggressive engine sound—without compromising reliability or warranty coverage.

Whether you use your truck for daily driving, work, or weekend adventures, this cold air intake helps your engine breathe better and perform at its full potential.

Vehicle Fitment

• 1998–2001 Ford Ranger 3.0L V6

• 1998–2001 Mazda B3000 3.0L V6

✔ Fits Automatic & Manual Transmissions

Key Features & Performance Benefits

• Boosts horsepower and torque by up to 10%

• T304 lightweight aluminum intake piping for durability and heat resistance

• High-flow air filter engineered for maximum filtration and airflow

• Improved throttle response for quicker acceleration

• Direct replacement for factory air box and intake tube

• Enhanced engine sound with a deep, sporty tone

• Washable and reusable filter – service every ~50,000 miles under normal driving

• No tuning required

• Will not void factory vehicle warranty

Why Upgrade from the Factory Air Box?

Factory air boxes are designed for noise reduction and cost efficiency—not performance. This cold air intake removes airflow restrictions, allowing your engine to pull in cooler, denser air for more efficient combustion.

Benefits you’ll notice immediately:

• Increased horsepower and acceleration

• Improved fuel economy under normal driving

• Sharper throttle response

• Sportier under-hood appearance

• Long-term savings with a reusable filter

Installation Information

• Bolt-on installation

• Uses factory mounting points and sensors

• Basic hand tools required (screwdrivers and socket wrenches)

• Typical install time: under 60 minutes

For best results, it is recommended to briefly disconnect the battery after installation so the engine computer can re-learn the increased airflow. Always disconnect the battery before performing engine work.